Sewing machine not picking up bobbin thread
When the needle thread cannot form a stitch with the bobbin thread, start with threading, needle and bobbin installation before assuming an internal timing failure.
Rethread the upper path completely
Raise the presser foot before threading so the upper thread can enter the tension path correctly. Make sure the take-up lever and every required guide are threaded according to the machine diagram. A thread that merely looks close to the correct path may still miss a guide.
Check the needle
Install a fresh needle of the correct system with the flat side/orientation exactly as the manual specifies. Push it fully into position before tightening. A bent, damaged, incorrectly inserted or wrong-system needle may not present the upper thread correctly to the hook.
Reinstall the bobbin
Use the correct bobbin type and follow the model-specific insertion direction and threading path. Drop-in and front-loading systems differ. Leave the bobbin tail as instructed by the manual.
Raise the bobbin thread using the manual method
Many machines allow you to hold the upper thread and turn the handwheel in the normal direction so the needle descends and rises, bringing a loop of bobbin thread through the needle plate. Some machines have different automatic procedures; follow the manual rather than forcing the wheel.
Clear accessible tangles
If thread is trapped under the plate, power off and follow the manual’s jam-clearing procedure. Remove cut thread and lint from accessible areas before reassembling correctly.
When timing/service becomes plausible
If a correctly threaded machine with the right fresh needle and correctly installed bobbin repeatedly fails to form a stitch—especially after a needle strike or jam—stop escalating adjustments. Hook/needle timing and damaged parts are service-level possibilities, not good first DIY adjustments.
A controlled diagnostic test
After rethreading and reinstalling a fresh needle/bobbin, remove the fabric and use the manual’s procedure to bring up the bobbin thread. Watch whether the upper thread travels around the bobbin area and returns with a loop. Do not put fingers near moving parts. If the machine forms the loop reliably without fabric but fails when sewing, move on to fabric/needle/thread compatibility and presser-foot setup rather than assuming timing.
If the failure began immediately after a severe jam or needle strike, note that history when seeking service. It is useful evidence. Avoid turning timing screws based on generic videos: hook clearance and timing are model-specific and incorrect adjustment can create a more expensive fault.