How to thread a sewing machine without guessing
The exact thread path is model-specific. Use your manual's diagram, but follow a repeatable verification routine so you know each part of the path is engaged.
Start with the manual and the correct spool setup
Identify the spool pin arrangement, cap/orientation and numbered thread guides for your exact model. A spool that unwinds incorrectly or catches on a notch can create intermittent problems even when the rest of the path is correct.
Raise the presser foot before upper threading
On many domestic machines, raising the presser foot opens the upper tension discs. SINGER specifically recommends threading with the foot raised when diagnosing loops underneath the fabric. Route the thread firmly through the designated tension channel without forcing it.
Make sure the take-up lever is actually threaded
The take-up lever controls slack as the stitch forms. Bring it into a visible position using the handwheel in the direction specified by the manual and confirm the thread passes through the lever rather than beside it. A missed take-up lever can create dramatic tangles underneath.
Follow every final guide near the needle
Small guides above the needle keep the thread aligned with the needle eye. Thread the needle in the direction specified for your machine. If your machine has an automatic needle threader, use only needle positions/sizes for which the manual permits it.
Bobbin setup is a separate path
Use the exact bobbin type required by the machine, wind it evenly and insert it in the stated direction. Front-loading and top/drop-in systems route bobbin thread differently, so a generic clockwise/counter-clockwise rule is unsafe. Follow the diagram printed on the machine or manual.
Bring up the bobbin thread if your model requires it
Some machines instruct you to hold the upper thread and turn the handwheel to pick up a loop of bobbin thread before sewing. Others use different arrangements. Follow the model instructions and place thread tails as directed.
Test the threading rather than trusting appearance
Sew on a folded scrap using an ordinary straight stitch. If loops form underneath, rethread the upper path before adjusting tension. If loops appear on top, recheck bobbin insertion. If the needle does not pick up bobbin thread, check the bobbin-winder position, needle installation and bobbin orientation using model support.
Primary source: SINGER machine FAQs and troubleshooting.