Learn · Beginner reference

Sewing machine tension: what to check before turning the dial

Tension is often blamed for any ugly stitch, but incorrect threading, bobbin insertion and needle choice can imitate a tension problem. Diagnose those first.

Quick rule: return to normal settings, rethread correctly, then make small upper-tension changes on a scrap only if the stitch evidence points there.

What balanced tension looks like

In an ordinary lockstitch, the upper and bobbin threads interlock through the fabric rather than leaving obvious loops on either surface. Exact appearance depends on fabric and thread, but large loops or one thread being pulled conspicuously to the opposite side are diagnostic clues.

Before adjusting anything

Install a suitable fresh needle, confirm the correct bobbin type and insertion, raise the presser foot and completely rethread the upper path. Brother notes that correct tension may be impossible if the upper thread or bobbin is incorrectly threaded. Test with ordinary thread on a folded scrap of the project fabric.

If bobbin thread shows on the right side

On models where the manufacturer describes this relationship, visible bobbin thread on the right side can indicate that upper tension is too tight. Make only a small upper-tension adjustment and retest. Record the starting value so you can return to it.

If upper thread shows or loops underneath

First rethread the upper path with the presser foot raised. Loops underneath frequently come from upper thread not being seated in the tension system. If threading is confirmed and the upper thread is still being pulled to the wrong side, follow your machine's model-specific tension procedure.

Why bobbin tension is not a beginner first step

Many domestic machines have bobbin tension set at the factory. Brother explicitly states this for models covered by its support guidance. Do not turn a bobbin-case screw because a generic article says to; the procedure varies and can make diagnosis harder.

Change one variable at a time

Sew labelled samples at the baseline and after each small adjustment. Keep needle, thread, fabric layers and stitch length constant. This turns troubleshooting into a controlled comparison rather than a series of guesses.

When tension is probably not the real problem

Skipped stitches, thread shredding, needle strikes, fabric not feeding or a jammed handwheel point to other checks. Extreme tension settings should not be used to compensate for an unsuitable needle, incorrectly installed bobbin or damaged thread path.

When to seek service

If correct threading, known-good thread, a fresh appropriate needle and ordinary settings cannot produce a normal seam on ordinary fabric, consult the exact machine manual/support route. Avoid internal timing or tension-assembly adjustments without model-specific expertise.

Primary sources: Brother thread-tension support and SINGER machine troubleshooting guidance.